Sprache: DeutschLanguage: EnglishIdioma: EspañolЯзык: РусскийJęzyk: PolskiSpJazyk: Česky

06.05..2015
NEW !
TURN-OVER SYSTEM FOR 3D-PRESSES

Click here to go to the webpage directly.

 



Rapha-Systems Handels - GmbH

Griesperwarth 3-4
A-3262 Wang - Austria
Telefon: +43(0)7488/71133
Fax: +43(0)7488/7113312
E-Mail: office@rapha-systems.at

 

HomeProdukteInnovationÜber unsKontakt

DownloadsLinksSitemapImpressumGebrauchte Maschinen






To enlarge click on the picture!

 


Starter Pinsystem

... with the STARTER Pinsystem for 3D-laminating presses.  

USING OUR KNOW HOW TO MAKE IT EASY

With a few hand movements you can arrange the workpieces with the RAPHA JIG.

Pins support the work replacing the need for the many different jigs. Exposed pins can be easily positioned as counter force to avoid foil pinching on the corners instead of searching for filler pieces.

From our long experience in foil pressing and the use of computer design technology we have developed the slightly magnetised pins used on the RAPHA JIG.
Every pin can be used to support workpieces of any size. To meet the requirements of all press manufacturers and users of the RAPHA JIG the pins are available in two heights of 15 and 18 mm.

Thinking out of the box ...

Too many manufactoring processes are done today in precisely the same way as when they were developed ten, twenty or even thirty years ago. The increasing globalization of the market in turn increases the pressure to continually improve products and their manufacture.



MORE about the many advantages of the RAPHA Jig pinsystem

  • Retro-fitted manual for installation in 3D laminating presses
    Note: Special variant of the RAPHA Jig Pinsystems possible - for 3D-Thermoforming with adhesive-pre-coated foils!
  • High precision, mechanical design for absolutely foolproof operation
  • Minimal installation and service cost because electronic, pneumatic and hydraulic components are not involved
  • Free alignment of the pins ensures complete flexibility
  • Absolute improvement of the vacuum power - the whole vacuum can take effect under the press-part (which otherwise the tie- plates cover up)
  • No standstill times of the press (because missing tie-plates)
  • Avoiding parts of waste produced by including dust under the foils
  • The basic plate protects also the aluminium press table against damage by cutting out the pressed parts.

Delivery contents:

-Pins - user-specific and as required
-Optional Basic-Plate - because the Pins are only adhere on the right material (for example they do not adhere on Aluminium!) and Vacuum can come through unhindered.

AVAILABLE FILMS (wmv-format):
Serial (38,6MB)
Serial (5,4MB)
Serial Realtime-Processing (2,9MB)



 
Design by www.werbecluster.at Design by www.werbecluster.at